Flow Full Open | 3.85 CFM at 100 psi 1.65 CFM at 45 psi |
Length | 9/16 in. |
Hex | 1/4 in. |
Thread | M5 |
Materials | Brass |
Item # 47200
Price Summary
- $29.59
- $29.59
- $29.59
For direct mounting on exhaust ports. Adjustable, equipped with locking nut to prevent tampering or loosening after setting is made.
Weight | 0.62 lbs |
---|
Be the first to review “Item # 47200” Cancel reply
You must be logged in to post a review.
Related Products
Item # 47086
For direct mounting on cylinder or valve ports, with L-banjo type instant push-in fitting and captive adjusting screw.
Item # 47091
For direct mounting on cylinder or valve ports, with L-banjo type instant push-in fitting and captive adjusting screw.
Item # 47080
For direct mounting on cylinder or valve ports, with L-banjo type instant push-in fitting and captive adjusting screw.
Item # 47085
For direct mounting on valve or cylinder ports, with captive adjusting screw and L-banjo type barb fitting.
Item # 47071
For direct mounting on valve or cylinder ports, with captive adjusting screw and L-banjo type barb fitting.
Item # 47090
For direct mounting on cylinder or valve ports, with L-banjo type instant push-in fitting and captive adjusting screw.
Item # 47070
For direct mounting on valve or cylinder ports, with captive adjusting screw and L-banjo type barb fitting.
Item # 47081
For direct mounting on valve or cylinder ports, with captive adjusting screw and L-banjo type barb fitting.
Recently Viewed
Item # 76420-02-04
Two sizes of manifold kits are available (1/8 and 1/4 ported) for standard directional control valves, pneumatically or electrically operated (4 way, In-Line type, 2 or 3 position, except valve types 76123, 76124, 76127). Manifolds are single piece aluminum bases with common supply and exhaust ports on each end (1/8 or 1/4 metric respectively). For NPT supply ports, order supply line adaptor kit separately. Manifold kits include all valve mounting hardware, which accommodates both NPT, or Metric ported versions of valves. A hollow bolt is used to connect the valve to the base and supply the line air pressure. Two brass sleeves, sealed with O-rings, connect the exhaust ports. If a valve station is unoccupied (for future use), a blanking bar kit must be used to block manifold ports. Manifolds can be fastened down by 4 threaded M5 holes. Two or more 1/8 ported manifolds can be linked together with the use of connecting nipples and threaded tie rods (up to 3/16″ dia.) using the through body holes on the sides of the manifold to increase the number of stations.
Item # 76410-02-13
Standard coils fit all general purpose solenoid valves, except ISO valves with CNOMO air pilots. Coils are encapsulated to keep out water, oil and other contaminants providing splash proof protection when used with sockets below. The 3-prong plug includes a ground connection for the coil frame. Terminals can also be connected using crimp-on wire terminals with a 1/4″ spade dimension. Coil power consumption: AC (60Hz) is 3.5VA, DC is 2.5 W.
Item # 76084-08-00
ISO standard valves, solenoid operated, are available in 2 versions of 3 position valves; with all ports open or all ports closed in the center (off) position.
For technical details of valves, contact factory. See accessory section for manifolds and sub bases.
There are no reviews yet.