|Timing Range||6 to 60 sec.|
|Operating Pressure Range||15 to 100 psi|
|Connections||10-32 or 1/8 NPT ports via bottom sub plate|
|Control Pressure||(A) Low Press. – 15 to 100PSI|
(B) Standard – 30 to 100 psi
|Media||Filtered air or non-aggressive gas, non-lubricated.|
|Timing Valve||Cv – 0.005|
Flow at 100 psi -0.1 CFM
|Dial Indicator||Displays set time|
|Timing Start||Application of pilot pressure to control port|
|Reset||Automatic by removal of pilot signal.|
|Reset Time||60 ms at 50 psi|
|Repeatability||± 3% of selected time|
|Time Setting||Via Adjustment Knob|
|Operation||Timing cycle uses atmospheric pressure drawn into vacuum.|
|Air Consumption||0.1 CFM at 100 psi|
|Materials||Acetal and polycarbonate enclosure|
Diaphragms – Buna N
|Operating Ambient||0 to 65 ºC|
32 to 150 ºF
|Height||2 1/16 in.|
|Width||1 1/2 in.|
|Depth||4 1/4 in.|
|Mounting||Via sub plate (2 holes) or if Panel mounted, through a 1 1/2″ square cutout. 2 mounting holes required, hardware included.|
|Low Pressure Version||The PMT standard control input pressure range is 30 to 100 PSI. For a low pressure pilot actuator (15 PSI min.), change the “B” in the catalog number to “A”.|
|Subplate Mounting Position||Standard timers are supplied with the subplatemounting position at the bottom of the timer. Formounting the subplate in another position, change thelast digit of the catalog number as follows: 1 for top; 2for right side; 3 for bottom; 4 for left side.|
|Power Connections||For installations requiring larger output valves, use thestandard timer and connect a pneumatically operatedsingle air piloted 3 or 4 way valve of the size required tothe timer output. Contact factory with sizerequirements.|
|Typical Circuits||See typical timing circuit diagrams at the end of the timer catalog section for help in constructing pneumatic timer circuits.|
Item # PMT1G1B3
The Type PMT timer is an adjustable precise time delay control device. The timer is available with an on delay (NC) logic output.
Timing operation is dependent upon the input of a separate control signal which starts the timing sequence by setting a vacuum within the timer. Using atmospheric pressure (independent of line pressure), the timer begins the preset timing cycle. At the end of the cycle an internal 3 way valve is switched providing an output. The timer resets automatically after removal of the control signal.
The PMT has a separate subplate enabling the unit to be supplied with 10-32 or 1/8 NPT porting. The timer can be panel mounted with a bezel, or in the rear on a sub plate.
There are no reviews yet.